|
|
| Supply voltage: | 115 o 230 V +10-15% |
| Frequency: | 45÷65 Hz |
| Power consumption (without outlets): | 4 VA max |
| Operating temperature: | 0÷60 °C |
| Storage temperature: | -20÷80 °C |
| Maximum relative humidity: | 75 % |
| Protection
class (when wiring, use adeguate connectors): |
IP54 |
| Mounting position: | any |
| Load protection fuse: | 3.15 A |
| Device protection fuse: | 1 A |
| Maximum output capacity: | 3 A @ 230 V cosj = 0.5 |
| Probe voltage: | 300 V ac |
| Minimum ionization current: | 3 mA |
| Flame current limitation: | 3.2 mA |
| Flame signal display: | 0÷90 mA |
| Prepurge time *: | 0÷255 s |
| First safety time: | 1÷25 s |
| Main burner stabilization time: | 1÷25 s |
| Reaction time: | 1÷20 s |
| Post-purge time *: | 0÷255 s |
| Auto shutoff (can be inhibited): | within 24 hours |
| Optional inputs voltage: | 24, 48, 115, 230 V ac/dc |
| Optional
inputs absorption (thermostat, pressure switch, limit switch): |
max
5mA |
| Lock/reset input absorption: | max 5mA |
| Filter for lock/reset input: | RC 100W - 0.47mF - 250 V ac |
| Casing: | thermosetting |
| Dimensions: | 200x120x93
mm |
| Mass: | 1200 g |
| Flame controlling device: | rod or UV-2 phototube (ESA) |
| Insulation
among probe conductors: |
> 50 MW (double-insulation or double-protection cables) |
| Rod or UV tube probe line length: | < 30 m |
| Unirod
probe line length with TAR-10 transformer: |
2
m max |
* When the EXP-1 expansion card is not provided, these values must be considered as idle time.